|
| |
TM5-4120-387-14
a.
Removal
(1) Using screwdriver, remove four screws and washers in intake grille
assembly.
(2) Remove grille.
(3) Snap filter out of ring clip.
b.
c.
(4) Careful
Clean filter
(1) Wash fi
ly remove filter.
lter in a mild detergent and water solution.
(2) Rinse thoroughly in clean water.
(3) Shake out excess water prior to installation.
Inspection
(1) Check filter for punctures, cuts, and damaged edges that would allow
passage of unfiltered air.
(2) Check filter for packed or mashed areas that would block air flow.
(3) Replace damaged filter.
d.
Installation
NOTE
Be sure air flow arrow points to evaporator fan as shown in
figure 4-21.
(1) Position left side of filter in bracket.
(2) Carefully push right side of filter to engage spring clip.
(3) Using screwdriver, secure intake grille assembly with four screws and
washers.
4-67
|
