|
| |
TM5-4120-387-14
(2) Check individual wires for loose solder connections, loose terminal lug
connections, cut or frayed insulation, and cut or broken wires.
(3) See wiring diagram (fig. 4-7) and continuity test individual wires.
Repair or replace wires with no continuity.
c.
Removal
(1) Using screwdriver and wrench, remove four screws and nuts from J4 and
J10 connectors. (See fig. 4-36.)
(2) Tag and disconnect leads from parts.
(3) Remove harness.
d.
Repair
(1) See paragraph 4-27 for general wire
(2) See table 4-3 (Wire List) for wire
when individual wires are replaced.
e.
Installation
repair instructions.
lengths and terminal information
(1) See tags and wiring diagram (fig. 4-7) and reconnect leads.
(2) Remove tags.
(3) Using screwdriver and wrench, secure J4 and J10 connectors and gaskets,
with four each screws and locknuts.
(4) Using screwdriver, secure junction box cover with four captive panel
fastener screws.
Follow-on procedure:
Install junction box.
(See para 4-29.)
4-40. TERMINAL BOARDS (TB1 AND TB2)
Preliminary procedure: Remove junction box.
(See para 4-29.)
a.
Access
(1) Using screwdriver, loosen four captive panel fastener screws in
junction box cover.
4-94
|
