| |
TM5-4120-387-14
a.
Inspection
(1) Check that parts are in place and that wires move freely in cable.
b.
Removal
(1) Using hex head wrench, loosen two screws on hub of condenser fan.
(2) Remove condenser fan and key.
(3) Remove knob, lockwasher and nut from cable.
(4) Using needle nose pliers, reach into condenser fan cavity and restrain
cable.
(5) Using wrench, remove control assembly nut.
(6) Pull cable out of unit through junction box side.
c.
Installation
(1) From junct
(2) Using
cable.
(3) Using
(4) Install
need
on box side, thread cable through rear panel opening.
e nose pliers, reach into condenser fan cavity and restrain
wrench,
install control assembly nut.
nut, lockwasher and knob.
(5) Install condenser fan and key flush to shaft of motor shaft.
(6) Using torque wrench with hex head socket, torque two screws to 82 inch
pounds.
Follow-on procedure: 1.
Install junction box.
(See para 4-29.)
2.
Install condenser air discharge guard. (See para 4-20.)
4-43. WIRING HARNESSES
Voltages used can kill.
Always disconnect power cord to air
conditioner before performing any internal maintenance.
Shutting unit off at its control panel does not disconnect
unit power.
4-98
|