Remote Mounting of Control Panel (Cont)

TM 5-4120-393-14

c. Sensing Bulb. Using screwdriver loosen screw (1) in clamp (2) that retains sensing bulb (3).

d. Remove Bulb. Slip sensing bulb (3) out of clamp (2).

e. Remove Line.

Remove grommet (4) and carefully guide capillary line and sensing bulb down into lower

compartment.

f. Secure Clamp. Using screwdriver tighten screw (1) in retaining clamp (2) for possible future use.

g. Disconnect Wiring. Disconnect wiring harness connector P8 (1) from connector J8 (2) on the control panel (3).

h. Remove Control Panel. Using a screwdriver, remove four screws (4) and washers (5) and remove control panel

(3) from air conditioner.

i. Coil Capillary Line. Very carefully coil capillary line (1) and mount sensing bulb (2) in loop clamp (3) provided on

the back of the control panel (4).

j. Mounting Holes. The control panel is provided with two sets of four holes. The control panel can be mounted

using the bottom or rear face holes.

k. Locate Panel. Care should be taken to locate the control panel and sensing bulb where there will be an accurate

temperature indication.

4-8