Installations That Require Removal of Fabric Cover

TM 5-4120-393-14

(2) Unscrew electrical connector cover (1) from connector.

(3) Using screwdriver and wrench, remove four screws (2) and nuts (3) from J1 connector (4).

(4) Remove J1 connector (4) and harness, rubber gasket (5), and electrical connector cover and chain (1) from

side panel.

(5) Using screwdriver and wrench, remove four screws (6), nuts (7), and cover plate (8) at alternate connector

location.

(6) Using screwdriver and wrench, install cover plate (8) on mounting plate where J1 connector was removed

with four screws (6) and nuts (7).

(7) Using screwdriver and wrench, install rubber g sket (5), connector J1 (4), electrical connector cover and

chain (1) in new location with four screws (2) and nuts (3).

(8) Reinstall lower front panel.

4-10. Installations That Require Removal of Fabric Cover. Some installations require the removal of the fabric cover.

This generally applies only when the air conditioner is positioned inside with condenser and fresh air openings ducted to

the outside.

NOTE

If the air conditioner is to be installed with condenser side (rear) exposed, the

fabric cover should be left in place if possible.

4-14