Installation Instructions - TM-5-4120-393-140067

TM 5-4120-393-14

a. Remove Fabric Cover. Using a screwdriver, remove two turnbutton fasteners (1), twenty two screws (2) and

washers (3). Carefully remove the fabric cover (4).

b. Store Cover. Store the cover in a safe place for future use.

c. Reinstall Hardware. Using screwdriver, reinstall all hardware removed in step a.

4-11. Installation Instructions. All alterations to the enclosure into which the air conditioner is to be installed should be

complete before installation of the air conditioner.

WARNING

Do not allow anyone under equipment suspended from a lifting device. Do not

allow the unit to swing while suspended from a lifting device. Failure to observe

this warning may result in injury to personnel and damage to the equipment.

CAUTION

Use care in handling to avoid damage to the air conditioner. If an overhead lifting

device must be used, use an appropriate sling so that the weight of the unit is

supported by the base of the shipping container.

a. Position Unit. Attach an overhead hoist, sling and spreader bar to the lifting rings on each side of the cabinet

and move the air conditioner into position and align mounting holes.

b. Secure Unit. Secure unit with appropriate mounting hardware.

Base - 0.4375-14 UNC-2B (4 holes)

Rear - 0.3125-24 UNF-3B (3 holes)

c. Seal Unit. Seal all openings around cutouts for air conditioner, air and water tight. Use gasket, caulking, or other

suitable material.

4-15