Relays (K1, K2, K7, and K8)

TM 5-4120-393-14

4-43. Relays (K1, K2, K7, and K8)

This task covers:

a. Removal

c. Testing

b. Inspection

d. Installation

Initial setup.

Tools:

Tool kit, service, refrigeration unit NSN 5180-00-596-1474

Personnel: 1

Equipment condition:

1. Turn unit power off at power source. If there is a chance that it will be turned on, also disconnect power

cable to air conditioner.

2. Remove lower front panel. See para 4-24.

General Safety Instructions:

WARNING

Disconnect input power to the air conditioner before performing any internal

maintenance. Voltages used can KILL. Shutting the unit off at the control panel

does not disconnect unit power.

REMOVAL

Using screwdriver, remove four screws (1) from junction box cover (2). Remove cover (2).

Remove nut (5), washer (6), and terminal cover (7) from relay (8).

NOTE

Inspection/Testing (installed) can be done at this point.

Tag and disconnect wire leads.

Using wrench, remove four nuts (3) and washers (4) and remove relay (8).

4-103