 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4120-393-14
5-28. Compressor (B1) (cont)
4.
Remove thermostat.
5.
Install new thermostat as follows:
a.
Insert thermostat and carefully bend retaining tabs back to secure thermostat.
b.
See tags on removed thermostat. Connect thermostat leads.
c.
If this completes the repair, install terminal box cover.
REPLACE HEATER HR8
NOTE
Refrigerant system discharge is not required.
1.
Check to see that the power has been disconnected at the power source and covers have been removed during
access and testing.
WARNING
Allow heater to cool before touching. Severe burns can result from touching hot
heater.
2.
Using screwdriver, remove two screws (1) from each of the two heater terminal covers (2).
3.
Remove two terminal covers (2).
4.
Tag and disconnect wire leads (3) and jumper (4).
5-70
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
