|
| |
TM 55-8145-221-14&P
0032 00-1
LIGHT ASSEMBLY (INTERIOR)
0032 00
THIS WORK PACKAGE COVERS:
Removal, Disassembly, Inspection, Repair, Assembly, and Installation
INITIAL SET-UP:
Maintenance Level
Unit
Tools:
Equipment Condition:
General Mechanics Tool Kit (Section III, Item 1, WP 0048 00)
Generator Set shut down (WP 0006 00)
Material/Parts:
Refrigeration Unit shut down (WP 0006 00)
Tags, Wire (Item 20, WP 0078 00)
REMOVAL.
1.
Open right rear door (1, Figure 1).
2.
Loosen screw (2) and remove guard (3) from fixture (4).
3.
Remove globe (5) and bulb (6) from fixture (4).
DISASSEMBLY.
NOTE
Disassemble components only to the level required to perform repair.
1.
From outside container (7), remove two screws (8), cover (9) and gasket (10) from box (11) on front panel (12).
2.
Tag wiring (13) with wire tags (Item 20, WP 0078 00) and remove three wire nuts (14).
3.
From inside container (7), remove two screws (15) and fixture (4) from electrical box (16).
4.
Tag wiring (17 and 18) with wire tags (Item 20, WP 0078 00) and remove three wire nuts (19).
5.
Remove two screws (20), switch (21) and gasket (22) from switch box (23).
6.
Tag wiring with wire tags (Item 20, WP 0078 00) and disconnect wiring (18) from switch (21).
7.
Remove conduit nut (24) from adapter (25) and slide nut along conduit.
8.
Remove two screws (26) from switch box (23) and two screws (27) from electrical box (16), and remove both boxes
from container (7).
9.
Remove adapter (25) from electrical box (16).
10. Loosen two conduit locking nuts (28) and remove boxes (16 and 23) from conduit (29).
11. Remove conduit nut (30) from adapter (31) and slide it along conduit (32).
12. Remove seven screws (33) and clamps (34) and remove conduit (32 and 35) from container (7).
13. Remove wiring (17) from conduit (32 and 35).
14. Remove two conduit nuts (36) and separate conduit (32 and 35) and union (37).
|
