|
| |
TM 55-8145-221-14&P
0034 00-1
REAR DOOR, RIGHT
0034 00
THIS WORK PACKAGE COVERS:
Disassembly, Cleaning, Inspection, Repair, and Assembly
INITIAL SET-UP:
Maintenance Level
Unit
Tools:
Material/Parts:
General Mechanics Tool Kit (Section III, Item 1, WP 0048 00)
Adhesive, Silastic (Item 3, WP 0078 00)
Portable Drill (Section III, Item 2, WP 0048 00)
Adhesive, Contact (Item 2, WP 0078 00)
Drill Bit Set (Section III, Item 2, WP 0048 00)
Blind Rivet (Item 22, WP 0081 00)
Rivet Tool (Section III, Item 10, WP 0048 00)
Bolt, Camtainer (Item 6, WP 008100)
Torx Socket (Section III, Item 7, WP 0048 00)
Detergent (Item 6, WP 0081 00)
Torx Bit (Section III, Item 6, WP 0048 00)
Foam, Urethane (Item 9, 0078 00)
Hoist (Section III, Item 14, WP 0048 00)
Wiping Rag (Item 18, WP0078 00)
Sling (Section III, Item 9, WP 0048 00)
Nut, Camtainer (Item 9, WP 0081 00)
Forklift (Section III, Item 15, WP 0048 00)
Solvent, Dry Cleaning (Item 11, WP 0078 00)
Personnel Required:
Equipment Condition:
Three
Generator Set shut down (WP 0006 00)
Refrigeration Unit shut down (WP 0006 00)
Escape Door removed (WP 0033 00)
NOTE
Disassemble rear doors only to the extent required to replace defective components.
DISASSEMBLY.
1.
Drill out 60 rivets (1, Figure 1) from back sheet (2).
2.
Carefully remove back sheet (2) from door seal (3) and insulation (4).
NOTE
Only insulation directly over brace levers and hinge mounting hardware needs to be
removed. Do not remove entire sheet of insulation unless damaged.
3.
Cut out and remove insulation (4) from mounting hardware, securing brace levers (5) and hinge (6) to door (7).
4.
Drill out 24 rivets (8) and remove two retaining strips (9).
5.
Drill out 42 rivets (8), and remove two retaining strips (10).
6.
Remove door seal (3).
7.
Remove 51 screws (11) and insulation retainer frames (12, 13, 14 and 15).
|
