Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: b. Removal.
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 9-4110-257-14 (3) Using multimeter set to measure continuity, check continuous duty solenoid (7) continuity between small  terminal  lugs.    Continuity  should  be  indicated.    If  continuity  was  not  indicated,  replace  continuous  duty solenoid. (4) Using multimeter set to measure continuity, check continuous duty solenoid (7) continuity between large  terminal  lugs.    Continuity  should  not  be  indicated.    If  continuity  was  indicated,  replace  continuous  duty solenoid. (5) Check  continuity  between  each  terminal  and  the  case.    No  continuity  should  be  indicated.    If continuity was indicated, replace continuous duty solenoid. NOTE Terminal hardware is supplied with continuous duty solenoid. (6) If  no  failure  was  indicated,  install  wire  leads  (4)  per  tags  and  wiring  diagram  (fig.    1-4),  lock washers (6), and nuts (5).  Remove tags. (7) Close control panel (3) and install two new lock washers (2) and bolts (1). b. Removal. (1) Be  sure  battery  has  been  disconnected  and  remove  two  bolts  (1)  and  lock  washers  (2).    Open control panel (3). Discard lock washers. NOTE Terminal hardware is supplied with continuous duty solenoid. (2) Tag wire leads (4) and remove nuts (5), lock washers (6) and wire leads. (3) Remove  two  bolts  (8),  lock  washers  (9),  flat  washers  (10)  and  continuous  duty  solenoid  (7). Discard lock washers. c.  Installation. (1) Install continuous duty solenoid (7), two bolts (8), new lock washers (9) and flat washers (10). NOTE Terminal hardware is supplied with continuous duty solenoid. (2) Using  tags  and  wiring  diagram  (fig.    1-4),  install  wire  leads  (4),  lock  washers  (6)  and  nuts  (5). Remove tags. (3) Close control panel (3).  Install two new lock washers (2) and bolts (1). NOTE FOLLOW-ON MAINTENANCE: Unlatch and close control panel cover door. Connect battery (para 4-35) and put unit back into service. 4-87

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business