|
| |
TM 9-4110-257-14
4-42.
ENGINE PULLEY REPLACEMENT.
This task covers:
a.
Testing
b.
Removal
c.
Installation
INITIAL SETUP:
Equipment Conditions:
General Safety Instructions:
Refrigeration unit shut down (para 2-7) and battery
WARNING
disconnected (para 4-35).
V-belts removed from engine pulley only (para 4-38).
Exposed rotating parts are used in the
refrigeration unit. Personal injury can result if
battery is connected.
a.
Removal.
(1)
Remove three bolts (1), and install two bolts back into threaded holes in bushing (2). Tighten bolts
evenly to separate bushing from pulley (3). Remove two bolts from bushing.
Figure 4-36. Engine Pulley
(2)
Slide bushing (2) and pulley (3) off engine drive shaft (4) being careful not to lose keys (5) and (6).
4-106
|
