|
| |
TM 9-4110-257-14
4-60. FUEL RETURN HOSES REPLACEMENT. - Continued
NOTE
Do not remove eye unless it must be replaced.
(e)
Remove union (10), washer (11), eye (12), and washer (13). Discard washers.
(2) Injection pump to fuel tank hose assembly.
(a)
Remove two screws (1), flat washers (2) and cylinder casing (3).
NOTE
The following procedures apply to both cylinders.
(b)
Remove three screws (4), cover (5), and gasket (6). Discard gasket.
(c)
Remove union (10), washer (11), eye (12), and washer (13). Discard washers.
(d)
Remove union (14), washer (15), eye (16), and washer (17). Discard washers.
(e)
Loosen clamp (18) and remove connector (19).
(3) Fuel tank hose assembly.
(a)
Cut tie down straps (20) and remove loom (21).
(b)
Loosen clamps (18) and (22). Remove hose (23).
NOTE
Connector, nut, and tube ferrule are not re-usable. Do not remove
unless any of these parts or fuel inlet elbow must be replaced.
(c)
If connector (24) is damaged, loosen nut (25) then remove connector and tube ferrule (26). Fuel inlet elbow
(27) may now be removed.
b.
Installation.
(1) Nozzle to injection pump hose.
NOTE
The following procedures apply to both cylinders.
(a)
If eye (12) was removed, install new washer (13), eye, new washer (11), and union (10).
(b)
Install hose (9) onto union (14) and secure using new clamp (8).
4-148
|
