|
| |
TM 9-4110-257-14
(c)
Install hose (9) over eye (12) and secure using new clamp (7).
(d)
Install new gasket (6), cover (5), and three screws (4).
(e)
Install cylinder casing (3), two flat washers (2) and screws (1).
(2) Injection pump to fuel tank hose assembly.
NOTE
The following procedures apply to both cylinders.
(a)
Install new washer (17), eye (16), new washer (15), and union (14).
(b)
Install new washer (13), eye (12), new washer (11), and union (10).
(c)
Slide clamp (18) over hose (23) end and install connector (19). Tighten clamp.
(d)
Install new gasket (6), cover (5), and three screws (4).
(e)
Install cylinder casing (3), two flat washers (2) and screws (1).
(3) Fuel tank hose assembly.
(a)
If removed, install fuel inlet elbow (27) onto tank (28).
NOTE
Connector, nut, and tube ferrule cannot be re-used. If removed, they
must be replaced.
(b)
If connector (24) was removed, install new nut (25) and new tube ferrule (26) onto new connector. Install
connector into fuel inlet elbow (27) and tighten nut to compress tube ferrule.
(c)
Slide clamp (22) over hose (23) end and install hose onto connector (24). Tighten clamp.
(d)
Slide clamp (18) over hose (23) end and install hose onto connector (19). Tighten clamp.
(e) Install loom (21) over hose (23) and secure using tie down straps (20) as necessary.
NOTE
FOLLOW-ON MAINTENANCE:
Close both side condenser doors.
Connect battery (para 4-35) and put unit back into service.
4-149
|
