|
| |
TM 9-4120-367-14
TM 07592B-14/1
6.29 MOTOR. This task covers disassembly, cleaning, inspection and assembly.
[ INITIAL SETUP ]
Applicable Configurations:
All except Model MHP-20-4-08
Test Equipment:
None
Special Tools:
None
Materials/Parts:
Safety Glasses
Solvent P-D-680
Detergent Solution
Cleaning Cloths
Tools (paragraph 3.1)
Abrasive Cloth
Gloves
Special Environmental Conditions:
None
General Safety Instructions:
See WARNING page
References:
None
Troubleshooting References:
None
Personnel Required:
Direct Support
Equipment Descriptions:
Power OFF; removed from shelter
Location/Item
Disassembly
Action
NOTE
Motors manufactured by IMC Mag-
netics Corp. do not come apart the
same way as those manufactured by
Welco Industries, Inc. See motor
name plate to determine who made
the motor.
IMC MOTOR
a. Remove four hex nuts, four through bolts, and
eight flat washers.
b. Remove rear end bell.
c. Pull out rotor.
d. Remove shims, bearing spacers and bearings.
e. Remove screw, washer, and loop clamp.
f. Remove screw, washer, and ground terminal.
Remarks
6-101
|
