|
| |
ARMY TM 9-4120-381-14
NAVY EE-000-CA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-31
6-7. THERMOSTAT BOX AND COVER - Continued.
Figure 6-2. Thermostat Box And Cover
REPAIR/REPLACE - Continued
4.
Remove insulator bushing (13).
5.
Install insulator bushing (13).
6.
Coat surfaces of metal and gasket with adhesive. Let both surfaces dry until adhesive is tacky but will not stick to
fingers.
7.
Starting with an end, carefully attach gasket to metal surface. Press into firm contact all over.
8.
Install grommet (1).
9.
Use sealant tape to seal holes between boxes, bushing, and conduit fitting.
10.
If required, drill out and replace damaged (total of eight) rivnuts (12).
INSTALLATION
1.
Place thermostat box (4) in mounting position.
2.
Install two screws (9), four flat washers (8), and two locknuts (7).
3.
Install two screws (2), four flat washers (3) and (5), and two locknuts (6).
4.
Install cool control thermostat (para 4-87).
FOLLOW ON PROCEDURE
Close rear evaporator panel (para 6-6).
6-6
|
