|
| |
ARMY TM 9-4210-381-14
NAVY EE-000-CA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-31
6-10.
REAR CONDENSER PANEL
This task covers:
Removal
Inspection
Repair
Installation
INITIAL SETUP:
Tools:
Tool kit, service, refrigeration unit (Item 1, Appendix B)
Electric portable drill (item 6, Appendix B)
Twist drill set (Item 7, Appendix B)
Riveter, blind set (Item 8, Appendix B)
Riveter, (Rivnut) (Item 9, Appendix B)
Gloves, chemical (Appendix C)
Personnel: 1
Materials:
Adhesive (Item 1, Appendix E)
Bulk gasket material
Bulk insulation material
Rags (Item 12, Appendix E)
Methyl-ethyl ketone (Item 13, Appendix E)
Equipment Conditions:
NOTE
For removal of the rear condenser panel the air conditioner may have to be removed from the van or
shelter. Refer to the van or shelter technical manual for removal or installation instructions.
1.
Remove condenser air out RFI filter (para 6-12).
2.
Remove condenser air in RFI filter (para 6-13).
REMOVAL
1.
Remove 42 screws (1), lockwashers (2), and flat washers (3) (see Figure 6-5).
2.
Remove panel (4).
INSPECTION
1.
Check that panel (4) is not bent, cracked, or punctured. Replace panel, if defective.
2.
Check that gaskets (5) are not torn, loose, or missing.
3.
Check for missing or damaged rivnuts.
REPAIR
NOTE
Repair consists of replacing RFI gasket, rivnuts or panel.
Gasket.
a.
Remove damaged gasket (5) from panel (4).
WARNING
Acetone and Methyl-Ethyl Ketone (MEK) are flammable and their vapors can be explosive. Repeated or prolonged skin
contact or inhalation of vapors can be toxic. Use a well ventilated area, wear gloves, and keep away from sparks or
flame.
6-11
|
