Major Air Conditioner Components.

TM9 4120-423-14&P

AIR CONDITIONER EQUIPMENT DESCRIPTION AND DATA EQUIPMENT

CHARACTERISTICS, CAPABILITIES AND FEATURES

0002 00

Major Air Conditioner Components.

Remote Control Assembly - The Remote Control Assembly has the Mode Selector Switch for choosing

between OFF, COOL, HI HEAT and LO HEAT, a rotary Temperature Control for controlling

temperature regardless of operating mode, and a visual indicator for power ON/OFF conditions. It may

be mounted remotely in the shelter, or mounted directly to the front of the air conditioner.

Evaporator Assembly - The Evaporator Assembly exhausts conditioned air, and intakes return air. It has

an opening on either side for ventilating outside air; these openings have fresh air covers installed.

These openings will accommodate mounting of fresh air duct assemblies. This assembly also has the

connection points for the input power cable and the remote control cable. An opening in the front cover

allows for optional mounting of Remote Control Assembly or a blocking plate.

Condenser Assembly - The Condenser Section has a cover permanently attached to the housing to

protect the rear face of the assembly. This assembly has a time-totalizing meter for displaying the

operating hours regardless of mode of operation. A sight glass is included on the assembly exterior for

visually inspecting the refrigerant during the Cool Mode. Both a low side and a high side service valve

are provided for use during maintenance, service and testing. Also a High Pressure Cutout (Reset)

Switch is on the assembly for resetting the switch, which has opened because of excessive refrigerant

pressure.

NOTE

The power cable assembly and the remote control cable assemblies are not provided as

part of the air conditioner. See installation instructions contained in WP0006, for general

instructions and the manual for shelter on which air conditioner is to be installed for

specific instructions pertaining to these cables. No separate remote cable is required if

remote control is mounted in unit.

The Model HSP24C30H Air Conditioner is designed to circulate and cool or heat air in the shelter or

enclosure on which it is installed.

The Model HSP24C30H has a capability of providing 24,000 BTU/HR of cooling and two stages of heat

rated at 18,000 BTU/HR (Low) and 30,000 BTU/HR (High). It is designed to maintain the air in the

shelter or enclosure at the desired temperature selected on the remote control assembly.

The unit is a split package air conditioner that is ideally suited for van or shelter type installations. The

only external requirements are a source of 208 volt ac, 3 phase, 400 hertz input power, power cable,

remote control cables (optional) and an entry to a suitable drain, lower than the base of the evaporator

section cabinet in its operating location, for disposal of condensate waste water. It is designed to operate

0002 00-1