 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9 4120-423-14&P
1
Tag leads.
2
Using pliers, remove quick-disconnect terminals and clear leads away from terminals.
3
Using screwdriver to retain the screws, remove the top three nuts with a socket and ratchet.
4
Lift the temperature control component board up and out of the box.
5
Check the remaining three nuts, spacers, and screws to be sure they are tight and in good
condition. Remove and replace them if they are damaged.
INSTALLATION
1
Place the temperature control component board on the three nuts, spacers, and screws that were
left in the box.
2
Use a screwdriver to retain the screws from the bottom of the box.
3
Using socket and ratchet, secure the temperature control component board with three nuts and
4
Install quick-disconnect terminals on terminals according to tags, wire markings, and wiring
diagram.
5
Remove tags.
6
Place cover on box and line up holes.
7
Using screwdriver, attach the cover with six screws and lockwashers. Do not over tighten, it will
cause distortion. See WP0041.
8
Install evaporator section electrical module assembly. See WP0032.
9
Install evaporator top cover. See WP0026.
0035 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals