 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9 4120-423-14&P
2
See Wire List for wire lengths and terminal information when individual wires are replaced.
TEST AND INSPECTION
1
Using screwdriver and wrench, remove eight screws, six nuts, and two lockwashers that hold
cover to chassis.
2
Pull cover away from chassis as far as wiring harness will allow.
3
Check connectors for general condition, loose, broken, or missing contacts. Replace connectors
if damaged.
4
Check individual wires for loose solder and terminal lug connections, cut or frayed insulation,
and cut or broken wires.
5
See wiring diagram and continuity test individual wires. Repair wires with no continuity.
6
Check that gaskets are in good condition. Replace them if they are torn, missing, or otherwise
damaged.
INSTALLATION
1
Using screwdriver and wrench, install the connector(s) in cover with screws and locknuts. Be
sure that EMI gaskets are placed between connectors and cover.
2
See tags and wiring diagram and reconnect leads. Remove tags.
3
Position cover on chassis.
4
Using screwdriver and wrench, secure cover with eight screws, six locknuts, and two
5
Install condenser section electrical module. (See WP0051.)
6
Connect power.
END OF TASK
0055 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals