|
|
TM 9-4120-428-14
0037 00
REMOVAL
1. Tag and disconnect individual wires.
2. Remove nuts and J3 through J6, J8 and J9 connectors from the unit.
3. Remove four screws (1) and nuts (2), eight flat washers (3), gasket (4), and cap and chain (5) from J1 connector.
4. Remove eight screws (6), lock nuts (7), flat washers (8), one screw (9), and a lock washer (10) from the J2
connector.
TESTING
See the wiring diagram (WP 0016 00) and conduct continuity tests on individual wires. Replace or repair wires with
no continuity.
REPAIR
1. See WP 0028 00 for general wire repair instructions.
2. See WP 0028 00, Wire List, for wire lengths and terminal information when individual wires are replaced.
3. Replace individual wires, terminals, or connectors if defective.
REPLACEMENT
If the harness is damaged beyond repair or connector J2 is damaged, replace the junction box wiring harness.
INSTALLATION
1. Install the J2 connector with one screw (9), lock washer (10), eight screws (6), lock nuts (7), and flat washers (8).
2. Install the J1 connector, gasket (4), and cap and chain (5) with four screws (1), nuts (2), and eight flat washers (3).
3. Install J3 through J6, J8 and J9 connectors. Secure with nuts.
4. Refer to Wiring Diagram (Fig. 4-4) and tag and connect the wire leads and connectors. Remove tags.
NOTE
FOLLOW-ON MAINTENANCE:
Install junction box (WP 0036 00)
Install top panels (WP 0019 00)
END OF WORK PACKAGE
0037 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |