REFRIGERATION UNIT RECEIVER TANK

TM 10-4110-262-13&P

0038 00

DIRECT SUPPORT MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

REFRIGERATION UNIT RECEIVER TANK

REMOVE/INSTALL

INITIAL SETUP

References

Tools and special tools

Refrigeration System Service (WP 0031 00)

Tool Kit, Refrigeration Service

Dehydrator Removal and Replacement

(WP 0051 00, Table 2, Item 5)

Materials and Parts

Refrigerant, R404A (WP 0068 00, Item 16)

Equipment Conditions

ADR-300 disconnected from all power Supplies.

Compressor Oil (WP 0068 00, Item 5)

Tank Receiver (WP 0059 00, Item 11)

Personnel Required

HVAC Technician (MOS 52C, AFSC 3E1x1) (1)

NOTE

The following procedures involve servicing the refrigeration system.

Some of these service procedures are regulated by Federal, and in some

cases, by State and Local laws. All regulated refrigeration service

procedures must be performed by an EPA certified technician, using

approved equipment and complying with all Federal, State, and Local

laws.

NOTE

Replace the dehydrator (see WP 0038 00) whenever the high side is

opened or when the low side is opened for an extended period of time.

REMOVE

1. Remove the condenser section top grille.

2. Recover the refrigerant charge.

CAUTION

Take care to avoid damaging nearby electrical and refrigeration

components when soldering and unsoldering. Protect nearby

components with a heat sink or other appropriate measure. Failure to

comply may result in damage to equipment.

3. Unsolder the refrigerant lines and remove them from the receiver tank.

4. Remove the mounting clamp.

5. Remove the receiver tank.

0038 00-1