Figure 12

MWO 55-8115-202-40-1

(14) Prior to installing the generator mount to the slides, extend the slides and spray-on Corrosion

Preventive Compound, NSN 8030-00-938-1947, MIL-C-81309D, Type II, Class 2 or equivalent.

Attach generator mount 30669-100 to slides using 8 countersunk screws, MS35190-287, at the

four corners and 12 screws (MS90725-5), 12 washers (MS27183-10), and 12 lock washers

(MS35338-44). The front of the slides should be located on the end of the mount with the

substructure having holes for locking bolts.

NOTE

Be advised that it is critical to follow the instructions and measurements exactly in

order to enable the proper alignment of the roller slides and generator mount

assembly. Failure to do so may result in significant rivnut misalignment and the

inability of the generator to be properly stowed, due to tight clearance/tolerance

requirements.

(15) Lay generator mount assembly in position on container and line up outside holes of slide

brackets with marks that were made in Paragraph (12) (Figure 12). (Assembling generator mount

to slides ensures proper alignment.) The front of the body of the slides (not the protruding locking

tab) should be 2 inches from the front edge of the container frame, but be sure that the holes are

12 7/16" from the inside edge of the frame upright (as shown in Figure 8A).

Figure 12