Compressor Installation. (Cont) - TB-9-2320-279-13-10405

TB 9-2320-279-13-1

NOTE

If vehicle was already equipped with a 130 amp

alternator, reuse 130 amp alternator and return

130 amp alternator included with kit to stock. If

vehicle was equipped with 65 amp alternator,

replace with 130 amp alternator included with kit.

15. Install key (27) and pulley (28) on shaft (29).

16. Clamp pulley (28) in vise with soft jaws.

17. Install locknut (30) on shaft (29) and tighten

locknut (30) until shaft (29) begins to turn.

18. Using lockjaw pliers, hold inside flange (31) of

pulley (28) and tighten locknut (30) to 70-85

ft-lbs. (95-115 Nm).

19. Remove lockjaw pliers and retorque locknut (30).

NOTE

Install alternator on mounting bracket with positive

terminal of alternator positioned towards driver's side

of vehicle.

20. Install alternator (32) on mounting bracket (7)

with screw (33) and locknut (34). Do not

tighten locknut (34).

21. Install alternator (32) on strap (18) with

screw (35), washer (36), lockwasher (37), and

locknut (38). Do not tighten locknut (38).

0052-13