AC COMPRESSOR DOES NOT SHUT OFF OR CYCLES CONSTANTLY - continued

DRAFT

TB 9-2320-364-13&P-1

AC COMPRESSOR DOES NOT SHUT OFF OR CYCLES CONSTANTLY - Continued

WARNING

Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around

vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short

across electrical circuits or terminals and cause damage to equipment or severe burns or

electrical shock to personnel.

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -

VOLTAGE TEST

(1) Disconnect AC harness AC condenser assembly

(2) Turn engine start switch ON (TM 9-2320-364-10).

(3) Place positive (+) probe of multimeter on AC

harness wire 1155 at AC condenser assembly

connector, terminal A.

(4) Place negative (-) probe of multimeter on a known

good ground.

(a) If 22 to 28 vdc are not measured, turn engine

start switch OFF and repair AC harness wire

1155 (see Appendix A) or replace AC wiring

harness (WP 0048). Verify repair, go to Step 15

of this fault.

(b) If 22 to 28 vdc are measured, go to Step 7 of

this fault.

VOLTAGE TEST

(1) Turn fan control switch to an on position (low,

medium, or high) (WP 0004).

(2) Turn temperature control switch to the coldest

position (fully clockwise) (WP 0004).

(3) If OFF, turn engine start switch ON

(TM 9-2320-364-10).

(4) Place positive (+) probe of multimeter on AC

harness wire 1156 at AC condenser assembly

connector, terminal B.

(5) Place negative (-) probe of multimeter on a known

good ground.

(a) If 22 to 28 vdc are not measured, turn engine

start switch OFF and repair AC harness wire

1156 (see Appendix A) or replace AC wiring

harness (WP 0048). Verify repair, go to Step 15

of this fault.

PLSAC174

(b) If 22 to 28 vdc are measured, turn engine start

switch OFF, and go to Step 8 of this fault.