INSULATED CONTAINER AND REFRIGERATION UNIT SERVICE

TM 10-4110-262-13&P

0014 00

OPERATOR MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

INSULATED CONTAINER AND REFRIGERATION UNIT

SERVICE

INITIAL SETUP

References

Tools and special tools

None

Equipment Conditions

Materials and Parts

ADR-300 disconnected from all power sources.

None

Personnel Required

Operator

GENERAL

This section outlines procedures for cleaning the ADR-300. In general, all surfaces should be cleaned

with non-abrasive cleaners and warm soap and water. Take care not to scratch the exterior paint or

interior panel surfaces.

The cleaning procedure generates a large volume of water run-off. Therefore, it is recommended that the

container be washed where the run-off will not affect other operations.

SERVICE

1. Remove all cargo from the IC interior and set aside in a protected area.

NOTE

If cargo requires continued refrigeration, place it in another refrigerated

container or cold storage facility.

2. Allow the IC interior temperature to rise so that all surfaces are above freezing.

3. Remove the drain plug from the container base and, if not captive, store the plug in a secure location.

4. Using a low-pressure water spray, wash down the container interior from top to bottom. If shelves are

installed, wash the shelves as well.

5. Use a non-abrasive sponge or rag and mild detergent on difficult soiled areas. A scrub or mild

abrasive brush may be used on the floor only.

6. Rinse all surfaces thoroughly and allow the washing liquids to drain from the shelter interior.

0014 00-1