SHELF ASSEMBLY REMOVE/INSTALL

TM 10-4110-262-13&P

0015 00

UNIT MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

SHELF ASSEMBLY

REMOVE/INSTALL

INITIAL SETUP

Tools and special tools

References

Tool Kit, Organizational Maintenance

None

(WP 0051 00, Table 2, Item 4)

Equipment Conditions

ADR-300 set up (See WP 0005 00 for set-up

Materials and Parts

None

procedures.

Personnel Required

(2)

GENERAL

This section describes procedures for removing and installing the ADR-300 shelf system.

REMOVE

To remove the shelf system, take the following steps.

1. Remove and store in an appropriate location all items supported by the shelves. Do not begin

disassembly with anything stored on any of the shelves.

WARNING

Be careful not to cut or break skin. Edges of the shelf

panels are sharp. Failure to comply may result in serious

injury to personnel.

2. Remove all (30) shelf panels from the supporting frames (shelf weldment) by lifting the panels straight

up. Stack the panels so that the ribs nest and stow them in an appropriate place.

3. Remove the four bolts supporting each shelf weldment and the three bolts securing the bottom

weldment to the IC floor. Remove each shelf weldment from the IC and stow the parts with the shelf

panels.

4. Remove the four bolts holding each top support to the long side supports. Remove the top supports

from the container and stow the parts with the shelf panels.

5. Remove the side supports from the container and stow them with the shelf panels.

0015 00-1