INTERIOR LIGHT ASSEMBLY REPLACE

TM 10-4110-262-13&P

0017 00

UNIT MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

INTERIOR LIGHT ASSEMBLY

REPLACE

INITIAL SETUP

References

Tools and special tools

None

Screw driver

Equipment Conditions

Materials and Parts

ADR-300 set up and connected to a power

Light bulb, Incandescent, 100 W

supply (See WP 0005 00 for set-up procedures).

Personnel Required

(1)

GENERAL

The light fixture inside the IC uses a conventional 100-Watt incandescent light bulb. This type of bulb

periodically fails and requires replacement. To replace the bulb, use the steps below.

REPLACE

Light Bulb

Loosen the setscrew that holds the cage in place.

2. Unscrew the protective cage from the fixture. Remove the cage and set it aside.

3. Unscrew the lens from the fixture in the same manner as the protective cage. Set the lens aside.

4. Remove the failed light bulb from the fixture. Dispose of the failed bulb.

5. Install a new bulb by screwing the new bulb into the empty socket by hand. Do not over tighten.

6. Turn on light switch to confirm light bulb works. If not refer to electrical system troubleshooting.

7. Replace the lens. Use only hand force to screw on the lens. Do not over tighten.

8. Replace the protective cage. Use only hand force to screw on the cage. Do not over tighten.

0017 00-1