IC POWER ENTRY CONNECTOR REPAIR AND REPLACE

TM 10-4110-262-13&P

0020 00

UNIT MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

IC POWER ENTRY CONNECTOR

REPAIR AND REPLACE

INITIAL SETUP

Personnel Required

Tools and special tools

Electrical Technician MOS 51 (AFSC 3E)

Tool Kit, Organizational Maintenance

(WP 0051 00, Table 4, Item 5)

References

Multimeter (WP 0051 00, Table 2, Item 2)

Materials and Parts

Equipment Conditions

IC Power Entry Connector

ADR-300 set up and connected to a power

source (See WP 0005 00 for set-up

Sealant (WP 0068 00, Item 21)

procedures).

Putty Knife (WP 0068 00 Item 14)

GENERAL

This work package outlines steps for testing, repairing and replacing the power entry connector on the

rear of the IC exterior. Before beginning this procedure, complete the IC electrical system test outlined in

Work Package 0018 00. The power entry connector should only be replaced by an identical assembly or

an approved substitute.

REPAIR

1. Confirm that power is disconnected from the IC power entry connector.

2. Remove the four screws that retain the cover plate for the input connector.

0020 00-1