REMOVE - TM-10-4110-262-13-P0157

TM 10-4110-262-13&P

0026 00

8. Tighten all screws until they are snug. Do not over tighten.

9. Verify proper operation of door handle.

REMOVE

Hook and Handle Assembly

1. Drive out the inside hook and handle assembly handle retaining roll pin.

2. Remove the setscrew on the inside assembly handle.

3. Remove the retaining nut and washer from the hook and handle assembly and slide the interior lock

handle of the shaft at the same time and set aside.

4. Remove the four mounting screws from the exterior lock mounting plate. Slide the exterior lock

assembly out of the IC wall and set aside.

INSTALL

1. Hold the exterior hook and handle assembly against the IC outer skin such that the lock axle passes

through the IC wall and the four screw holes on the hook and handle assembly mounting plate.

2. Align with the holes in the container skin.

3. Thread the four mounting screws through the mounting plate into the IC skin.

4. Thread the retaining nut onto the hook and handle assembly axle and slide the interior lock handle to

tighten until the handle rotates with a little resistance.

5. Align the holes and drive the roll pin in.

6. Install the setscrew.

7. Verify the proper operation of the hook and handle assembly.

END OF WORK PACKAGE

0026 00-5/(6 Blank)