FREEZER DOOR KEEPER REMOVE/INSTALL

TM 10-4110-262-13&P

0027 00

DIRECT SUPPORT MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

FREEZER DOOR KEEPER

REMOVE/INSTALL

INITIAL SETUP

References

Tools and special tools

None

Tool Kit, Organizational Maintenance

(WP 0051 00, Table 2, Item 4)

Equipment Conditions

No required condition

Materials and Parts

Keeper Freezer Door (WP 0054 00, Item 7)

Personnel Required

1 person

REMOVE

1. With a knife, scribe around the perimeter of the keeper to cut the sealant. Be careful to avoid cutting

or gouging the container skin.

2. Remove the four mounting screws from the keeper exterior (see figure).

3. Remove the keeper assembly from the IC.

NOTE

If needed, gently tap the keeper to loosen it from the container surface.

INSTALL

1. Remove any residual sealant from the container surface with a knife.

CAUTION

Take care to avoid damaging the paint or IC skin. Failure to comply may

result in damage to equipment.

2. Hold the keeper in position on the container surface and align the four holes in the keeper with the

threaded inserts in the IC.

3. Thread the four screws through the keeper and into the threaded inserts. Tighten the screws

securely.

0027 00-1