INSTALL - TM-10-4110-262-13-P0201

TM 10-4110-262-13&P

0033 00

NOTE

Note the level of oil in the compressor. This amount of oil will be added

to the replacement compressor.

19. Perform an acid test on the oil.

Suction Pressure

Regulator Valve

Bracket

Suction Line

Electrical Box

LPCO

HPCO

Compressor

Mounting Nut

Compressor Motor

Discharge

Mounting Spacer

Line

INSTALL

NOTE

Any compressor installed in this system must contain the proper amount

of compressor oil (see the Specifications section). When installing a new

compressor, add Polyol Ester oil to the compressor to equal the amount

of oil in the compressor removed. Always check to make sure that the

compressor contains the proper amount of oil. Follow the system

cleanup procedures to remove old oil from the system.

1. Place the compressor in position and install the four mounting nuts.

2. Wrap the suction pressure regulator with a wet cloth.

3. Remove the service valve gaskets. Clean the surfaces.

4. Install the new service valve gasket.

0033 00-3