REMOVE - TM-10-4110-262-13-P0204

TM 10-4110-262-13&P

0034 00

WARNING

Evaporator and condenser coil fins are sharp and can severely cut hands

and other exposed body parts on contact. Take care to avoid contacting

coil fins. Failure to comply may result in serious injury to personnel.

CAUTION

Be careful to avoid bending or damaging evaporator and condenser coil

fins. Damaged fins will reduce ADR-300 performance. Protect fins with

a rigid cover while working on or near either coil. Failure to comply may

result in damage to equipment.

REMOVE

1. Recover the refrigerant charge.

2. Remove the condenser or evaporator cover as appropriate.

CAUTION

Take care to protect surrounding components from heat during soldering

and unsoldering.

3. Locate the tubing section to be replaced and the closest solder joints in both directions along the

tube.

4. Unsolder both joints and remove the tube section.

INSTALL

CAUTION

Do not contaminate the system when preparing refrigeration tubing for

soldering. Contamination may cause restrictions in the refrigeration

system. Failure to comply may result in damage to the equipment.

1. Clean the mating surfaces of the tubes for soldering.

2. Assemble the tube components in the location in which they will be soldered.

3. Solder the connections taking care to protect nearby components from heat.

4. Perform a system cleanup as described below:

0034 00-2