UNIT CONTROLLER REMOVE/INSTALL

TM 10-4110-262-13&P

0036 00

DIRECT SUPPORT MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

UNIT CONTROLLER

REMOVE/INSTALL

INITIAL SETUP

References

Tools and special tools

PMCS Instruction (WP 0010 00)

Tool Kit, Organizational Maintenance

(WP 0051 00, Table 2, Item 4)

Equipment Conditions

ADR-300 disconnected from all sources of

Materials and Parts

power.

Controller M13 (WP 0060 00, Item 9)

Personnel Required

HVAC Technician (MOS 52C, AFSC 3E1x1) (1)

REMOVE

1. Open the controller enclosure by turning the handle -turn.

2. Loosen one set screw on each side of the controller.

3. Gently remove the controller from the enclosure to the extent of the connected wires.

4. Slide the terminal cover plate off the controller by pinching the grip points.

5. Remove two terminal plug connectors from the back of the controller.

6. Remove the controller.

INSTALL

CAUTION

Be careful not to pinch the wires. Failure to comply may result in

damage to equipment.

CAUTION

Ensure terminal leads are firmly seated in the terminal connector. Leads

can pop out of the connector and continuity will be lost. Failure to

comply may result in damage to equipment.

1. Install the two terminal plug connectors in the back of the controller.

0036 00-1