EVAPORATOR FAN REPLACE

TM 10-4110-262-13&P

0041 00

DIRECT SUPPORT MAINTENANCE

ADVANCED DESIGN REFRIGERATOR, 300 CUBIC FOOT (ADR-300)

4110-01-465-4158 / 4110-01-465-4564

EVAPORATOR FAN

REPLACE

INITIAL SETUP

References

Tools and special tools

Tool Kit, Organizational Maintenance

None

(WP 0051 00, Table 2, Item 4)

Equipment Conditions

Materials and Parts

ADR-300 disconnected from all sources of

Fan & Motor Evaporator (WP 0060 00, Item 2)

power.

Personnel Required

(1)

REPLACE

WARNING

The components on the evaporator coil have sharp edges

and will cut hands and other exposed skin surfaces. Take

care to avoid contact with the components. Place a folded

piece of cardboard or other device over the fins to protect

the worker while working near the coil. Failure to comply

may result in serious personal injury.

CAUTION

The evaporator coil fins are fragile and easily bent or otherwise

deformed. Deformed fins reduce the performance of the refrigeration

system. Place a folded piece of cardboard or other device over the fins to

protect the fins while working near the coil. Failure to comply may result

in damage to the equipment.

1. Disconnect the evaporator fan motor wires at the connector nearest the motor and cut the wire tie that

restrains the wire.

2. Remove the four bolts that hold the fan in the baffle. Remove the fan.

3. Position the replacement fan in the baffle plate opening. Install the four bolts and torque to 10 ft-lbf.

4. Connect the fan electrical leads to the fan power connector. Secure the loose wires as appropriate.

5. Connect the ADR-300 to an appropriate power supply and turn the unit on.

6. Verify that the air flow is blowing across the evaporator coil. If not, replace the evaporator fan.

0041 00-1