TM 10-8145-222-23
0032
SERVICE CONTINUED
4. Disconnect electrical connector (Figure 2, Item 1) from Electro-Magnetic Interference (EMI) shield assembly
(Figure 2, Item 2) located on top of fuel tank.
5. Remove 18 screws (Figure 2, Item 3), lock washers (Figure 2, Item 4), and washers (Figure 2, Item 5) securing
EMI shield assembly (Figure 2, Item 2) to fuel tank (Figure 2, Item 6). Discard lock washers.
NOTE
Use care not to damage EMI shielding on cover.
6. Carefully lift EMI shield assembly (Figure 2, Item 2) from fuel tank (Figure 2, Item 6) and rest on its side to
access fuel pump (Figure 2, Item 7).
WARNING
There will be residual fluid when removing this item. Be sure to use spill kit below to
catch residual fluid.
7. Remove clear cover (Figure 2, Item 8) and gasket (Figure 2, Item 9) from end of fuel pump (Figure 2, Item 7)
using channel locks or strap wrench.
8. Inspect gasket (Figure 2, Item 9) for tears or rips.
If gasket appears damaged, replace with new gasket and then continue to next step.
If gasket does not appear to be damaged, continue to next step.
NOTE
If filter is being replaced, install the new filter instead of cleaning old filter. The filter
should be cleaned every 400 hours of operation.
9. Remove and clean filter element (Figure 2, Item 10) using water and allow to dry.
10. Reinstall filter element (Figure 2, Item 10) into clear cover (Figure 2, Item 8).
11. Reinstall and secure gasket (Figure 2, Item 9) and clear cover (Figure 2, Item 8) to fuel pump (Figure 2, Item 7).
12. Connect battery negative (-) cable to battery (WP 0053, Reconnect).
13. Connect electrical connector (Figure 2, Item 1) to EMI shield assembly (Figure 2, Item 2).
14. Start refrigeration unit in diesel engine drive mode and check for leaks around fuel pump (TM 10-8415-222-10,
Operating Procedures).
15. Shut down refrigeration unit (TM 10-8415-222-10, Operating Procedures).
16. Disconnect electrical connector (Figure 2, Item 1) from EMI shield assembly (Figure 2, Item 2).
17. Disconnect battery negative (-) cable from battery (WP 0053, Disconnect).
18. Carefully install EMI shield assembly (Figure 2, Item 2) into place on fuel tank (Figure 2, Item 6).
19. Install 18 screws (Figure 2, Item 3), new lock washers (Figure 2, Item 4), and washers (Figure 2, Item 5) to
secure EMI shield assembly (Figure 2, Item 2) to fuel tank (Figure 2, Item 6).
0032-2
