TM 10-8145-222-23
0058
REPLACE CONTINUED
13. Install fuel pump, but only place cover on top of fuel pump without attaching (WP 0032, Install).
14. Install filler tube into filler neck flange (Figure 1, Item 26).
15. Fill fuel tank with fuel (WP 0012, Service).
16. Install fuel tank cap (Figure 1, Item 18).
17. Check fuel tank, elbows, and fittings for leaks.
18. Secure fuel pump cover if no leaks are present (WP 0032, Install).
19. Reconnect battery (WP 0053, Reconnect).
20. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
END OF TASK
REPAIR
Replace Liquid Level Gauge Assembly
WARNING
The JP-8 and diesel fuels used with the MTRCS are combustible and highly
explosive. Do not smoke or use open flame when performing maintenance. Flames
and explosion can occur resulting in severe injury or death.
The JP-8 and diesel fuels used with the MTRCS are toxic. Always wear eye, face,
and hand protection when working with or around fuel. If fuel contact is made with
eyes, flush your eyes and seek immediate medical attention. If fuel contact is made
with skin or clothing, remove contaminated clothing immediately, clean your skin with
a mild soap or cleanser, and rinse with clean water.
CAUTION
The fuel tank will retain a small amount of fuel even after it has been drained. Fuel
lines will have some fuel in them that will drain out when disconnected. Use cleaning
rags to clean up any spills when performing the following tasks.
1. Drain fuel from fuel tank into suitable container (WP 0012, Service).
2. Remove four screws (Figure 2, Item 10), lock washers (Figure 2, Item 11), washers (Figure 2, Item 12), and
spacers (Figure 2, Item 13), securing guard (Figure 2, Item 14) to fuel tank (Figure 2, Item 9). Discard lock
washers.
3. Remove guard (Figure 2, Item 14).
4. Remove two screws (Figure 2, Item 30) securing outer gauge cover (Figure 2, Item 31) to gauge facing
(Figure 2, Item 32).
0058-5