Thermometer

TM 5-4110-204-13

panel is too saturated to dry out, the

(d) Apply epoxy mixture and patch material

insulation must be replaced in the panel.

from repair kit as specified.

T h e 1800J model refrigerator has

(e) Apply tape over the entire patch area and

polyurethane insulation.

the panel is ready for use.

c. Installation Refer to paragraph 2-4, and install

(f) For damaged areas up to 144 sq. in., follow

the refrigerator panels.

above steps for use of repair kit, but apply epoxy to

cloth, nylon, or like type material which has been cut

3-31. Thermometer

to 2 to 3 inches greater in each direction of the hole to

be covered.

a. Removal. Refer to paragraph 2-5, and remove

(g) Affix the patch over the damaged area

the thermometer from the door panel.

(h) Tape the patch in vertical and horizontal

b. Installation Refer to paragraph 2-5 and install

directions so that the patch will not move while

the thermometer on the door panel.

curing. It will take approximately 2 hours for the

patch to adhere properly.

3-32. Drain Strainer

(2) Major Repairs.

a. Removal. Refer to figure 3-14, and remove the

(a) Obtain a metal plate large enough to cover

drain strainer.

the damaged area.

b. Intstallation. Refer to figure 3-14, and install the

(b) Apply a watertight sealer between the

drain strainer.

metal plate and the surface of the panel to be

repaired.

3-33. Slide Botts

secure it with sheet metal screws.

a. RemovaL Remove the four screws that secure

NOTE

the slide bolts to the partition panels, and remove the

If the fiberglass insulation should become

slide bolts.

saturated with moisture due to leakage of

b. Installtion Position the slide bolts on the

the panel, the panel should be removed

partition panels, and secure them with four mount-

ing screws.

and the moisture baked out of it. If the

Figure 3-9. Walk-in door ha miles and striker latch removal, installation and adjustment.

Change 5

3-10