Section V. TROUBLESHOOTING - TM-5-4110-217-140040

TM 5-4110-217-14

3-14.

Fuse Replacement.

Refer to figure 3-7 for fuse replacement. Remove

fuse cap and fuse. Install new fuse, as necessary, and

replace fuse cap.

Figure 3-7. Fuse Replacement

Section V. TROUBLESHOOTING

b. This manual cannot list all malfunctions that may

3-15.

General

occur, nor all tests or inspections and corrective actions.

a. This

section

contains

troubleshooting

If a malfunction is not listed or is not corrected by listed

information for locating and correcting most of the

corrective actions, notify your supervisor.

operating troubles which may develop in the refrigeration

unit. Each malfunction for an individual component, unit,

NOTE

or system is followed by a' list of tests or inspections

Before you use this table, be sure you have performed all

which will help you to determine probable causes and

applicable operating checks.

corrective actions to take. You should perform the

tests/inspections and corrective actions in the order

listed.

Table 3-3. Troubleshooting

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

If electrolyte is below top of plates, add distilled or

ENGINE (Model RMP-J/1-10G)

clean water until electrolyte level is three-eighths of

an inch above the separators. Recharge batteries

ENGINE FAILS TO CRANK WHEN STARTER BUTTON IS

or replace battery.

DEPRESSED.

Step 2.

Inspect for loose, corroded, or broken battery

cables. Clean corroded cables. Tighten loose

Step 1.

Check to see if electrolyte level in battery cells is

connections at battery, ground, and starter.

above the top of the plates.

Replace defective cables.

Change 3 3-8