Section II. MOVEMENT TO NEW WORKSITE

b. Make sure the unit has capacity to cool the space in which it is

installed.

c. Connect the unit to 115 volt, single phase, 60-cycle only.

d. Make sure the unit is sealed so that no air will escape around

the unit.

e. The unit must be installed so that there is access to either

the bottom panel (filter opening) or the top panel for access to the

filter.

f. Connect a drain hose to the bottom pan even though the lower

filter access panel is not used. Make sure the filter has two rubber

pads on the bottom and is not resting on the drain hole, or the bottom

pated during the installation in the particular installation.

h. There are two threaded holes under the unit 1 inch from each

side to which mounting bolts should be installed through the above

brackets (figure 2).

Section II.

MOVEMENT TO NEW WORKSITE

Dismantling for Movement

a. Disconnect the power supply cord assembly.

Remove all mounting bolts under the unit (para 9).

c. Remove all sealing angles from around unit.

Carefully slide the unit from the wall.

e. Use wood blocking and steel strapping to secure the unit to

carrier for long distance moving.

11. Reinstallation After Movement

Reinstall after movement as specified in paragraph 9.

Section III.

CONTROLS AND INSTRUMENTS

General

This section describes, locates, illustrates, and furnishes the op-

erator, crew or maintenance personnel information pertaining to the

various controls and instruments for proper operation of the air condi-

tioner.