|
|
TM 5-4120-352-14
stall coil and bonnet assembly and secure with two
b. Coil Replacement. Replace coil as follows:
screws.
valve leads.
Fan Motors.
6-8.
(2) Remove nut on top of valve housing. Lift
housing and coil assembly from bonnet assembly.
(3) Remove coil from housing.
evaporator fan motor are identical. Therefor, the
(4) Install coil bottom plate with edge upward.
following instructions apply equally to either mo-
tor.
(5) Install lower coil sleeve with flange at bot-
tom. Install coil with lead exits and bottom.
semble motor as follows:
(6) Install coil spring with flat edges upward
(1) Remove four hex nuts (1), four through
and upper coil sleeve with flage at top. Sleeve passes
bolts (2), and eight flat washers (3). Remove rear
through the coil spring.
end bell (4).
(7) Install coil housing, data plate and nut.
(2) Pull out rotor (9) and remove shims (5)
c. Bonnet Assembly and Diaphragm Replace-
and (6), bearing spacers (7) and bearings (8).
ment. Replace parts as follows:
(3) Remove screw (10), washer (11), and loop
clamp (12). Remove screw (13), washer (14), and
move two screws from body flanges and lift housing,
ground terminal (15). Disconnect leads and remove
coil and bonnet assembly (4) from body. Lift out di-
cable (16) and strain relief bushing (17). Remove
aphragm.
connector.
(2) To replace bonnet assembly, remove coil
housing and coil ( b above) from bonnet assembly.
mal protector housings (21) and (25), thermal pro-
(3) Assemble coil and bonnet assembly. Install
tectors (22) and (26), and attaching hardware. Re-
diaphragm and preformed packing (3) on body. In-
move front end bell (27) from stator (28).
Index, Figure 6-4. Fan motor, exploded view.
15. TERMINAL
1. NUT, HEX
16. CABLE
2. BOLT, THROUGH
17. BUSHING, STRAIN RELIEF
3. WASHER, FLAT
18. CONNECTOR
4. END BELL, REAR
19. SCREW
5. SHIM
20. WASHER
6. SHIM
21. HOUSING, THERMAL PROTECTOR
7. SPACER, BEARING
22. THERMAL PROTECTOR
8. BEARING, BALL, ANNULAR
23. SCREW
9. ROTOR
24. WASHER
10. SCREW
25. HOUSING, THERMAL PROTECTOR
11. WASHER
26. THERMAL PROTECTOR
12. CLAMP, LOOP
27. END BELL, FRONT
13. SCREW
28. STATOR
14. WASHER
6-7
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |