 |
|||
|
|
|||
|
Page Title:
Figure 3-21. Removal, installation and testing of rectifier |
|
||
| ||||||||||
|
|
 TM 5-4120-356-14
REMOVAL OF RECTIFIER
REFER TO PARAGRAPH 3-10o FOR PRELIMINARY
1.
STEPS IN THE REMOVAL OF THE RECTIFIER.
REMOVE EIGHT SCREWS (1) AND WASHERS (2)
2.
AND PULL BRACKET (3) FREE FROM JUNCTION
BOX (4).
REMOVE NUT (5) AND WASHER (6) AND PULL
3.
RECTIFIER (7) FROM BRACKET (3).
4. TAG AND DISCONNECT ELECTRICAL LEADS
FROM RECTIFIER (7).
INSTALLATION OF RECTIFIER
1.
CONNECT ELECTRICAL LEADS TO PROPER
TERMINALS ON RECTIFIER. REMOVE TAGS
FROM LEADS.
2. POSITION RECTIFIER (7) ON BRACKET (3)
AND SECURE WITH NUT (5) AND WASHER (6).
3. POSITION BRACKET (3) IN JUNCTION BOX
(4) AND SECURE WITH EIGHT WASHERS (2)
AND SCREWS (1) .
4. REFER TO PARAGRAPH 3-10o FOR FINAL STEPS
IN INSTALLATION OF THE RECTIFIER.
SHORT CIRCUIT CHECK
CONTINUITY CHECK
TS5412035614/3-21
TABLE B
TABLE A
RECTIFIER TEST
REMOVE THE RECTIFIER FROM THE CIRCUIT.
1.
REFER TO TABLE A AND CONTINUITY CHECK THE
2.
RECTIFIER. REPLACE RECTIFIER IF ANY OPEN
CIRCUIT IS FOUND.
REFER TO TABLE B AND SHORT CIRCUIT CHECK
3.
THE RECTIFIER. REPLACE THE RECTIFIER IF
RECTIFIER SCHEMATIC DIAGRAM
ANY SHORT CIRCUIT IS FOUND.
Figure 3-21. Removal, installation and testing of rectifier
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals