Compressor (cont) - TM-5-4120-356-140111

TM 5-4120-356-14

(j) Connect the recovery line to the tubing at point "D".

( k ) Start the pump and flush t h e line for approximately 10 minutes

then turn the pump off.

( l ) Switch the pump lines so t h a t the recovery line is connected to

t h e tubing at p o i n t "F" and the discharge line i s c o n n e c t e d t o t h e t u b i n g a t p o i n t " D " .

( m ) Start the pump and flush t h e line for approximately 10 minutes

t h e n turn the pump off.

( n ) Remove the discharge line from the tubing at point "D" and the

r e c o v e r y l i n e f r o m the tubing at point "F".

( o ) Cap the tubing at points "F" and `D", uncap the tubing at

p o i n t "E" and o p e n t h e v a l v e a t p o i n t " B " . "

( p ) Connect the discharge line to the tubing at point "E" and con-

nect the recovery line to the valve at point "B".

( q ) Start the pump and flush t h e line for approximately 10 minutes

then turn the pump off.

( r ) Switch the pump lines so t h a t the recovery line is connected to

t h e tubing at point "E" and the discharge line i s c o n n e c t e d t o t h e v a l v e a t p o i n t " B " .

( s ) S t a r t t h e p u m p a n d f l u s h t h e line for approximately 10 minutes

then turn the pump off.

( t ) Remove the discharge line from the valve at point "B" and close

the valve at point "B".

( u ) Remove the cap from the tubing at p o i n t "C" and connect the

discharge line to the tubing at point "C".

( v ) Start the pump and flush the line f o r approximately 10 minutes

t h e n turn the pump off.

( w ) Switch the pump lines so that the r e c o v e r y line is connected to

t h e tubing at p o i n t " C " a n d t h e d i s c h a r g e l i n e i s c o n n e c t e d t o t h e t u b i n g a t p o i n t " E " .

( x ) Start the pump and flush the line for approximately 10 minutes

t h e n turn the pump off.

( Y ) Refer to figure 3-12 and remove plug P3 from the junction box.

(z) Energize the pressure equalizer solenoid valve (12) by apply-

i n g 24 volts dc across pins E and F of plug P3.

( a a ) Remove the recovery line from the tubing at point "C" and cap

t h e tubing at point "C".

4-21