SOLENOID VALVE (COIL REMOVAL).-Continued

TM5-4120-383-14

4-38.

SOLENOID VALVE (COIL REMOVAL).-Continued

Remove.

(1) Remove top nut that attaches coil to the valve body.

Remove coil, data plate, and connector plug.

(2) Cut plastic tie down straps as necessary to remove

solenoid valve cable.

(3) If connector plug is to be reused unsolder it from leads.

(4) If grommet is to be reused remove it from defective coil

assembly.

Installation.

(1) Slip grommet over leads and install in hole in coil

assembly.

(2) Solder leads from coil assembly to connector plug.

(3) Place coil assembly and data plate on to valve body and

secure with nut.

(4) Reconnect connector plug.

(5) Secure wires to existing harnesses with new plastic tie

down straps or lacing cord.

(6) Install top rear cover (para 4-11) and fabric cover (para

(7) Connect power at power source.

4-107