 |
|||
|
|
|||
|
Page Title:
CONDENSER AIRE DISCHARGE LOUVER AND LINKAGE. - Continued |
|
||
| ||||||||||
|
|
 TM5-4120-384-14
4 - 1 7 . CONDENSER AIR DISCHARGE LOUVER AND LINKAGE. - Continued
(c)
Remove five screws and
lock
washers
and
two
snap
fasteners from frame.
(d)
Slide
louver
assembly from
unit.
a n d replace
if
damaged.
(e)
Inspect
all
parts
linkage assembly
as
follows:
(3)
Install
louver
and
(a)
Slide louver assembly into unit and secure with
five
screws and lock washers and two snap fasteners.
u s i n g screw and two washers.
(b)
Install
pivot
arm
DANGEROUS CHEMICAL is used in this equipment.
DEATH
or
severe
injury may result if personnel
fail
to
observe safety precautions.
Do not attempt to loosen or remove any of the
connections to the copper tubing.
Exercise great care to avoid contact with liquid
refrigerant or refrigerant gas being discharged under
pressure.
Sudden and irreversible tissue damage can
result from freezing.
Loosen two nuts securing actuating
cylinder
to
(c)
mounting bracket (fig. 5-14).
(d)
Slide actuating cylinder towards the condenser
louvers until the louvers are completely closed.
(e)
Tighten two nuts securing
the
actuating
cylinder
to
the mounting bracket.
(f)
Install
condenser
air
inlet
guard
(Models F18H-3S and F18H-1S) Install top rear cover
(g)
(Models F18H-3SA and F18H-3SB) Install top cover
(h)
Connect power at power source.
4-52
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals