 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-4120-384-14
4-39.
COIL
(CLEANING).-Continued
(2) (Models F18H-3S and F18H-1S) Install top rear cover and
fabric cover (para 4-11).
(Models F18H-3SA and F18H-3SB) Install
top cover (para 4-11).
(3)
Connect
power
at
power source.
4 - 4 0 HOUSING.
Inspect/Service.
a.
Check for missing, loose,
or damaged hardware.
Replace
all
missing or damaged hardware.
Inspect
for dents, bends, and cracked welds.
b.
Refer
defects
to
be
repaired
to direct support maintenance.
4-41.
CONNECTORS
(INSTALLATION).
There
are three connectors
supplied
with
each
air
a.
conditioner.
(See fig. 4-36.)
(1) Input power cable connector (P1). This connector is used
at the unit end of the input power cable.
It can be connected to
the J1 receptacle located above the control module or the J11
receptacle located on the upper left rear corner of the unit.
If the
J11 receptacle is used see
and
4-2 for wiring changes.
Figure
4-36.
Connectors
(Installation)
4-116
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals