 |
|||
|
|
|||
|
Page Title:
CONTROL MODULE -REPAIR/SERVICE. - continued |
|
||
| ||||||||||
|
|
 TM 5-4120-386-14
4-24. CONTROL MODULE-Continued.
REMARKS
ACTION
LOCATION/ITEM
Replacement-
Continued
Remove pin and middle
a.
20. Compressor
sections of throw switch.
Circuit
Remove six screws (42), and
Breaker
b.
six flat washers (43) securing
switch to front plate (47).
Slide switch (44) through
c.
back of front plate (47).
Clean contacts. Replace
d.
switch if contacts are damaged.
Replace if failed test.
e.
Reassemble in control module
f.
if passed test.
21. Control
Remove screw (48), flat washer
a.
(50) post spacer (52), locknut
Module
(49), and clamp (51) securing
Wiring
temperature selector switch
Harness
sensing line to back plate (47).
Remove seven screws (53), seven flat
b.
washers (55), and seven locknuts
(54) securing connector plug to
back plate (47).
Remove comector with leads from
c.
back plate (47).
Replace wires if damaged or failed
d.
test.
Desolder wire from connector pin.
e.
Measure old wire and cut new wire
f.
to that length.
Strip insulation from wire ends.
g.
Crimp required contacts on appro-
h.
priate wire ends.
Print wire identification number
i.
on shrink sleeving and shrink on
appropriate wire end.
4-52
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals