Cable Connections Through Return Air Duct (Cont)

TM 5-4120-393-14

d. If control panel is to be mounted in a remote location and remote control cable connector is to be connected

through air duct:

(1) See paragraph 4-7 for control panel relocation.

NOTE

Fabrication of interconnecting remote control cable described in paragraph 4-7 will

not apply to control cable for return air duct application using the J26 control cable

connector. See para 4-8 for this cable.

(2) Remove plastic dust caps (1) from connectors J27(2), J26 (3) and J24 (5). Store caps in a safe place for

possible future use.

(3) Connect P8 (4) to J27 (2) located on top of junction box.

(4) Install interconnecting cable from J26 to J8 on remote mounted control panel.

This cable must be

fabricated to the required length.

NOTE

This cable is applicable only to the remote control cable connection thru the return

air duct J26 connector.

(5) Using screwdriver install lower front panel.

4-12