(MODELS AA600PF, M1200PFA, AND M4000PF) REMOVE/TEST/INSTALL ELECTRICAL PLUG AND COVER.

TM 9-4110-241-13

TO 35E9-274-1

4-26. (MODELS AA600PF, M1200PFA, AND M4000PF) REMOVE/TEST/INSTALL ELECTRICAL PLUG AND COVER.

a. Tools: Screwdriver, cross-tip; Pocket Knife; Multimeter.

b. Removal:

WARNING

Shut off power supply at its source before beginning this procedure.

(1)

Slide plug seal cover off electrical plug.

(2)

Loosen retaining clamp screws.

(3)

Separate halves of electrical plug by removing screws.

(4)

Tag and disconnect wires to electrical plug.

(5)

Slide off plug seal cover.

Figure 4-20. Electrical Plug and Cover (Models AA600PF, M1200PFA, and AA4000PF)

c. Test:

(1) Attach a 125VAC power source to electrical plug.

(2) Use a multimeter to check for current flow.

d. Installation:

(1)

Slide cover on to power supply cord.

(2)

Slide cap of electrical plug over cord.

(3)

Connect wires to terminals of electrical plug connector.

(4)

Attach halves of electrical plug with screws.

(5)

Tighten screws to secure clamp.

(6)

Slide plug seal cover over plug.

4-42