 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-4120-425-14&P
LOUVER ACTUATOR CABLES UNIT MAINTENANCE - Continued
0032-00
INSTALLATION
1.
Install control bracket (11), bracket (18), four lock washers (17), and four screws (16).
2.
Loosely install cable (5) into angle (15) with nuts (10) and thru plastic tube to angle (12) on condenser fan scroll
(13).
3.
Loosely install inner set of nuts (10) onto louver actuator cables (5) and (6).
4.
Insert end of cables through angles (12) on condenser fan scrolls (13) and (14). Loosely install outer set of nuts (10).
5.
Loosely install two mechanical posts (8) and screws (9) onto ends of louver actuator cables (5) and (6).
6.
Loosely install inner set of nuts (7) and insert plain cable end through control bracket (11) and into bracket on
louver actuator (19). Loosely install outer set of nuts (7).
7.
Loosely install two mechanical posts (4) and screws (3) onto ends of louver actuator cables (5) and (6).
8.
Loosely install cable clip (2) and screw (1) to hold louver actuator cables (5) and (6).
ADJUSTMENT
CAUTION
The louver actuator cables must be adjusted when air conditioner is shut down and
cool. If cables are adjusted while unit is not completely cool, cables may be damaged
and improper operation of air conditioner may occur.
1.
Position the blades of both louver assemblies to a fully closed position.
2.
Tighten and position nuts (10) together until both nuts are seated hard against the angle (12) on the condenser fan
scrolls (13) and (14).
NOTE
The cable's outer sheath should project one inch from angle (12).
3.
Loosen nuts (7) at control bracket (11) to allow louver actuator cables (5) and (6) to be easily moved into the
bracket on the louver actuator cylinder (19).
NOTE
The cable's outer sheath should project approximately one inch for cable (5) and approximately one-
half inch for cable (6).
4.
Install the mechanical posts (4) into louver actuator. Insert cable wires into posts (4) and tighten screws (3).
5.
Tighten and position four nuts (7) on louver actuator cables (5) and (6) until each nut is seated hard against control
bracket (11).
6.
Install the mechanical posts (8) into louver arm (20). Insert cable wires into post (8) and tighten screw (9).
7.
Tighten screw (1) to secure louver actuator cable (5) and (6) against the cable mounting bracket (18).
0032-01-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals